I made a SEX Video for you - Strange Electronics eXperience:
Measuring the voltage between the batteryholder's plus and the IO board's plus when Servos are moving - the voltage over ONE connection (wires, switch, pin) is about 0.1 to 0.4 volts.
Assuming the minus side is the same then there are up to 0.8 volts eaten by the wiring between battery and servo connector.
Measuring the voltage between the batteryholder's plus and the IO board's plus when Servos are moving - the voltage over ONE connection (wires, switch, pin) is about 0.1 to 0.4 volts.
Assuming the minus side is the same then there are up to 0.8 volts eaten by the wiring between battery and servo connector.
Camilo Parra Palacio there are not only these 0.8V, when measuring directly at the battery holder I have 6V, when switching the servos on the voltage drops down to 4.3V (at the battery holder!). So I made another measuring at the V and G pins of IO board = 3.2 to 3.6V remaining (and the servos are still working but without load).