Skip to main content
❓ Question
Jim Desposito
Resident Tinkerer
Asked a question 2 months ago

Hi, I built the basic Otto and it works great using OttoBlocky to program it. I then tried to hook up the BLE module I had from a Nybble project (it seems to be the same as recommended in the instructions) but while it connected to the app (red LED changed from blinking to steady) I can't get any actions or sounds from Otto using the app. I tried RX to 12, TX to 11 and also RX to 11 and TX to 12 (since there's a warning about the pins being inverted when you load the BT example). Is the BLE the problem? If not, any suggestions on where the problem might be?

For more content join our community, sign up and become an Otto Builder now!