Bill SCHONFELDER Master Builder

3,239

Senior Designer

@bram h If I was to help I would start to reverse engineer your steps.  Are you running the new blockly 1.4.3 or the beta version 1.4.2 is where I would start first.  I only know from my own... (More)

@gabriela Try it from the main site. I also have had problems loading it up in 1.4.3.  I know that 1.4.2 works.  You must load up the program first.  Then shut off otto.  Next you run either... (More)

Walmart (More)

Adhesive foam for feet a must. First off if you have not tried foam on your ottos feet, then your missing out on some great friction free traction.    Today I programmed Shorty a very Ott... (More)

@gabriela I use this before assembly to center my servos. https://www.amazon.com/dp/B07RTK8GH4/ref=cm_sw_r_cp_apa_glt_fabc_ZDKS1N3N3Z728A9GYM5V?_encoding=UTF8&psc=1 (More)

It works great. Here is what I did to make it work for me in the steps I took, maybe it will help someone else out. 1. Dont have the robot hooked up to the usb or at least on.  2. Open blo... (More)

I can see where you are going with the confirmation, specially for kiddies.  Good call.  Personally I think everything is fine as it is. The size is good enough for the kiddies.  You don't w... (More)

@Piers Kennedy Tested out the program on a normal otto. Very impressed.   Now to be sure if I hit the save button, does this permanently write to the eprom for this one otto?  Can a test be ... (More)